So you can specify a smaller unit to achieve the same high performance.
Unlike unvented cylinders BoilerMate A-Class does not require an annual service
The appliance's advanced construction ensures a long life and the primary store design removes the need for annual checks on sacrificial anodes, found on many unvented units.
Will produce more than twice the hot water per hour of most stainless unvented cylinders
Sufficient to fill a bath in under 4 minutes, BoilerMate A-Class SP is eminently suitable for multi-bathroom properties. A powerful shower can also be used without the need for expensive pumps.
SWITCH 'peace of mind' for the installer, developer and homeowner in the event of a boiler failure comes as standard
It’s like having a service engineer with each unit - instant response to boiler failure restores heating and hot water at the press of a button.
BoilerMate A-Class SP is a true appliance. With all its system components concealed behind a beautifully engineered outer case, it consigns cupboard pipework to the history books and turns installation time into minutes.
On board diagnostics that can be interrogated remotely and fault tolerant electronics give robust performance
Manual fill – no overflow or run-off pipe needed
Easy
to transport, handle & install
All models are supplied
shrink wrapped with built in
moulded lifting handles. All controls and pipe-work are
mounted on the front face of the unit for ease of
installation and maintenance. Gledhill’s revolutionary design enables
rapid second fixing using copper or approved plastic piping.
Storage Vessel
Plumbed and wired
with:
- SWITCH emergency heating and hot water back up
- Grundfos UPS pump - Boiler circuit
- Grundfos UPR pump - Hot water
- F&E Tank complete with fittings
- Full control and diagnostic system
- Clock- electro-mechanical or digital
- Fixing pallet
- Plate heat exchanger
There is no requirement for:
- Motorised valves and boiler bypass
- Pressure or temperature relief valves
BoilerMate A-Class SP is for fitting to sealed systems. For open vented
systems, separate literature is available on our BoilerMate A-Class SP
by calling our sales office or visiting our web site.
- The immersion heater and primary coil can never scale
because they are in primary water
- BoilerMate A-Class is designed to cope on the
secondary side with most hard water situations
(<280ppm). For extreme situations (>280ppm) we
can supply a Gledhill in-line scale inhibitor fitted for
very little extra
Approvals
BoilerMate has been tested by WRAS, a member of the European Organisation for Technical approvals (EOTA) and found to comply with Water Regulations. In performance, it complies with the requirements of BS6700 and meets the NHBC criteria for domestic properties. Gledhill Water Storage Ltd also operates a quality management system audited and accepted by the BSI in accordance with BS EN ISO 9001:2000.
Technical Specification for BoilerMate SP A-Class
Please Click Here for SAP information
