So you can specify a smaller unit to achieve the same high performance.
Unlike unvented cylinders BoilerMate A-Class does not require an annual service
The appliance’s advanced construction ensures a long life and the primary store design removes the need for annual checks.
Will produce more than twice the hot water per hour of most stainless unvented cylinders
Sufficient to fill a bath in under 4 minutes, BoilerMate A-Class is eminently suitable for multi-bathroom properties. A powerful shower can also be used without the need for expensive pumps.
SWITCH 'peace of mind' for the installer, developer and homeowner in the event of a boiler failure comes as standard
It’s like having a service engineer with each unit - instant response to boiler failure restores heating and hot water at the press of a button.
BoilerMate A-Class is a true appliance. With all its system components concealed behind a beautifully engineered outer case, it consigns cupboard pipework to the history books and turns installation time into minutes.
On board diagnostics that can be interrogated remotely and fault tolerant electronics give robust performance
All pumps can be supplied as modulating for reduced running costs and noise for a modest extra charge
Easy
to transport, handle & install
All models are supplied
shrink wrapped with built in
moulded lifting handles. All controls and pipe-work are
mounted on the front face of the unit for ease of
installation and maintenance. Gledhill’s revolutionary design enables
rapid second fixing using copper or approved plastic piping.
Storage Vessel
Plumbed and wired
with:
- SWITCH emergency heating and hot water back up
- Grundfos UPS pump - space heating
- Grundfos UPS pump - Boiler circuit
- Grundfos UPR pump - Hot water - modulating
- F&E cistern complete with fittings
- Full control and diagnostic system
- Clock- electro-mechanical or digital (option)
- Fixing pallet
- Plate heat exchanger
There is no requirement for:
- Motorised valves and boiler bypass
- Pressure or temperature relief valves
BoilerMate A-Class is for fitting to OPEN VENTED
systems. For sealed systems, separate literature is
available on our BoilerMate A-Class SP by calling our
sales office or visiting our web site.
- BoilerMate’s immersion heaters can never scale
because they are in the primary water
- BoilerMate A-Class is designed to cope on the
secondary side with most hard water situations
(<250ppm). For extreme situations (>250ppm) we
can supply a Gledhill in-line scale inhibitor fitted for
very little extra (no fused spur required).
Approvals
BoilerMate has been tested by WRAS, a member of the European Organisation for Technical approvals (EOTA) and found to comply with Water Regulations. In performance, it complies with the requirements of BS6700 and meets the NHBC criteria for domestic properties. Gledhill Water Storage Ltd also operates a quality management system audited and accepted by the BSI in accordance with BS EN ISO 9001:2000.
Technical Specification for BoilerMate OV A-Class
Please Click Here for SAP information
